How do you cover an ATV seat?

What material can you use to cover a ATV seat?

ATVs are not only fun to ride for all ages but are also subject to wear and tear after prolonged usage. Many of the users often neglect that seats are also one of the essential components of the ATV. Like all other parts, seats also lose their qualities as they age. Since this vehicle is designed for off-road terrains, the seats are likely the first to wear and tear because of persistent exposure to the sun, water, dirt, and other environments. Therefore, in this article, we shall discuss how to change an ATV seat. 

It usually depends upon the condition of the seat itself, which determines if the cloth needs to be replaced or the whole seat itself needs to be upgraded. 

The first step is to remove the seat from the ATV, which is very simple. 

All you need to do is reach the left rear fender of the ATV to locate the seat’s latch. Once located, lift the latch upward, and you have successfully unlocked the seat. Now pull the seat upward and set it aside. 



How To Change Your ATV Seat Cover? 

You can follow the following steps to change your ATV seat. 

Step 1: Gather All The Tools 

Since you’re about to change your seat, the first thing you need to do is gather all the necessary tools required to do so. You will need the following. 

  1. Flat-head screwdriver
  2. Needle-nose pliers
  3. Scissors 
  4. Staple gun 
  5. 1/4-inch staples 

Step 2: Remove The Old Staples

Now, what you must do is to free up the old fabric from the foam. To do so, you need to remove all the staples with the help of the screwdriver. Inspect the foam thoroughly once all of the staples are removed, and the fabric is free. If it has large holes or has tears in it, then it means you have to replace the foam first. Otherwise, it can be reused again. 

Step 3: Install New Seat Cover

Now your next step is to install the new seat cover. Usually, all new seat covers come with a pre-stitched front piece that adjusts according to the front part of the seat. Once you have put it on you, you need to flip the seat upside down and staple the top part of the cover. We usually recommend three stapes on the top part. 

Step 4: Stapling The Cover

Now you need to staple the cover to the seat in succession. For every 6 inches, you need to pull the seat’s cover backward and staple evenly on each side as you progress downwards. In this way, you will not have any wrinkles on the seat. Moreover, you must inspect the seat side by side by flipping it upside down and ensuring it is smooth. If it is not smooth, repeat the procedure by removing the staples. 

Step 5: Rear Of The Seat 

Your job is almost done; the rear part of the seat is a little bit tricky. You need to make waves in the fabric and install a new staple after every half inch. This will ensure the cover contour to the curves and rounded edges of the seat. Once you have stapled the rear, ensure the seat is smooth and wrinkle-free. Finally, staple the seat all the way around at every inch, and you’re ready to go. 

Step 6: Scissor of the remaining Fabric

Now that you have stapled everything, your final job is to cut off the remaining extra fabric, and you’re ready to install the seat back into your ATV. 


Our Best 3 ATV covers to buy

  1. Kemimoto ATV Seat Cover for £31.54 – Check here on Amazon
  2. Kolpin Seat Cover for £24.40 – Check here for prices on Amazon
  3. Tarazon ATV Seat Cover for £43.72 – Check here for prices on Amazon


Other posts:

Recent Posts